the vehicle harness. position to check for intermittent open circuits (with NGS monitoring TR_D). : 003/97 Issued: 03/27/97 Revised:
Turn the ignition lock cylinder to "RUN." Connect SST (NGS) to data link connector. Always review the CAUTION ^ b. ^ Install an "Authorized Modification" label (P/N 9999-95-AMDC-97) with the new calibration
4.
DISCLAIMER lbs.) Page 32 Symptom Code 82
^ 4x4 HIGH-approximately 1.1 kilo ohms
press the Trigger key to select YES or NO for the 4.
CAUTION:
Set (1) Install the tool on the valve stem Crankshaft Free End Play
Push a piston into a cylinder to the bottom of ring travel using a piston without rings. Failure to do so may damage the semiconductor components. - Catalyst Efficiency Monitor Service Tips
Harmonic Balancer - Crankshaft Pulley: Specifications KAM is not cleared the PCM may remember operating conditions present before your repairs. 1. .......................................................... 0.127 (0.05) Max. - Torque the bolt to 25 Nm (18 lb-ft)
Measure the piston pin bore diameter in two directions on each side. 4. - Uses a rotary potentiometer that is rotated by throttle shaft. occurrence could cause the switch to overheat, smoke or burn which could result in an under hood Verify the crankshaft journal clearance. Disconnect battery ground cable. Trim the excess "ear" from the end of the clamp to 2.5cm (1 in.). 4.
C. Check for restrictions or kinks in the radiator or heater hoses. Remove the two screws and washer assembly which attach the Disconnect the vehicle speed sensor connector. Check that the connection is secure by applying a slight tug to the
The APPLICABLE Select "Retrieve/Clear Continuous DTCs." Check that the steering linkage and radius arm are not bent
not updated to the latest WDS calibration level, the calibration file will not install into the PTU. 4. These show the circuits for each system, from the power supply to the ground. specification.
@ 1.585 .............................................................................. 5.
Do not open the damper, with any kind of tool, in order to reassemble. 3. 1. As throttle plate is opened or closed, Shorts occur between the power (positive) and ground (negative) sides of a circuit.
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty.
If it is a remote reservoir, pinch the supply hose with your fingers two or three times to help move PID is certain data values, analog and digital inputs and outputs, calculated value, and system A new or efficient catalytic converter will have a switch ratio near 0, while a failed Install a new powertrain control module and install the two nuts.
Page 236 How do I check my tire pressure?
Perform the CMP SENSOR SYNCHRONIZER INSTALLATION However, LONGFT does this over a long period of time, in response to Are components and wiring OK? Refer to 3. 1. Disconnect the RABS control unit connector. Page 279 cause a fire.
MOTOR Start button.
hour or has been driven for less than 3 miles.
Additional refrigerant oil may be needed which exceeds the amount specified in the workshop
3. Check all parts, including rims, lug studs, lug nuts, and mating surfaces of hubs and tire rims for - Waveform appears similar to a sine wave ............................................................. Common Con.
finding a short circuit requires determining how the circuit is routed. This position is 60 degrees BTDC
Tightening torque: 27 Nm (20 ft.lbs.) Tightening torques: 8-11 Nm (61-87 in.lbs.)
Exterior Lighting Module: Electrical Diagrams Verify customer complaint A wheel or tire should be replaced if any cracks, damage, deformation or other problem(s) are If the Always review the
Loosen the inner locknut using the SST.